Zkusím, ale musím sehnat, je dlouhý.
Ale vypadává i ten terminál a ten má svůj. To mi došlo včera, protože se mi na PC vše projevovalo v pořádku a terminál se snažil připojit při platbě, ale nikdy jsem to tomu nepřipisoval. Na druhý pokus vždy OK, takže tipuji stejný problém.
Výpadky netu na pracovním PC
Moderátor: Mods_senior
Re: Výpadky netu na pracovním PC
Sestava v profilu.
Watercooling Club EXOverclocker@HWBot league rank#1 Aprilia Shiver Club BMW ///M Club
Watercooling Club EXOverclocker@HWBot league rank#1 Aprilia Shiver Club BMW ///M Club
-
Uziv00
Re: Výpadky netu na pracovním PC
Jinak bridge mod by to mělo umět: https://www.youtube.com/watch?v=xRcQPQRHpyQ
Re: Výpadky netu na pracovním PC
Haha, jo, díky. Tam jsem si toho vůbec nevšiml.
Pokud by to bylo tím boxem, vyřeší mi to další router?
Pokud by to bylo tím boxem, vyřeší mi to další router?
Sestava v profilu.
Watercooling Club EXOverclocker@HWBot league rank#1 Aprilia Shiver Club BMW ///M Club
Watercooling Club EXOverclocker@HWBot league rank#1 Aprilia Shiver Club BMW ///M Club
Re: Výpadky netu na pracovním PC
Your device supports the bridge mode and you can use this service from
your service provider to access the Internet.
1. Ensure that your device can connect to the Internet by using your
nano-SIM card automatically.
2. Log in to the 5G CPE configuration web page.
3. Change the operation mode to Bridge Mode. The device will be
restarted automatically.
NOTE:
Please disconnect from the Internet first and then you can change the
mode.
4. The first client connected to your device will obtain the IP address
from the WAN DHCP host and connect to the Internet directly.
NOTE:
The other clients cannot access the Internet. You can use those clients
to log in to the 5G CPE configuration web page.
your service provider to access the Internet.
1. Ensure that your device can connect to the Internet by using your
nano-SIM card automatically.
2. Log in to the 5G CPE configuration web page.
3. Change the operation mode to Bridge Mode. The device will be
restarted automatically.
NOTE:
Please disconnect from the Internet first and then you can change the
mode.
4. The first client connected to your device will obtain the IP address
from the WAN DHCP host and connect to the Internet directly.
NOTE:
The other clients cannot access the Internet. You can use those clients
to log in to the 5G CPE configuration web page.
Windows 11 PRO 64bit, Základní deska: Asus TUF Gaming B650E-WIFI, CPU: AMD Ryzen 5 9600X, Grafická karta: XFX Mercury AMD Radeon RX 9070XT 16GB Gaming Edition, Ram: Kingston FURY 32GB KIT DDR5 6000MHz CL30, Disk: WD Blue SN580 2TB, Chladič: Endorfy Fera 5, Zdroj: MSI MAG A850GL PCIE5
-
- Podobná témata
- Odpovědi
- Zobrazení
- Poslední příspěvek
-
- 7 Odpovědi
- 8522 Zobrazení
-
Poslední příspěvek od vasekpetr1
-
- 4 Odpovědi
- 6410 Zobrazení
-
Poslední příspěvek od RIKI22


